RAILTEC DIN RAIL PCB SUPPORTS

 Dimensions:

 Ordering Notes:
 * Supply 1pc each
 * Minimum components for one support: 2 end covers, extruded base (cut to size), DIN-Rail foot element plus 4 assembly screws
 * Extruded Base Section - xxx = Your PCB length less 4mm (we will supply the base extrusion pre-cut to this dimension)
    e.g. 200mm PCB = base extrusion cut to 196mm - order Part # CIME/M/BE196
    Please note minimum length for extruded base section 100mm
 * Foot Element - suitable for EN 50 022 (TS 35)/ ...035 (TS 32)/ ...045 (TS 15) rails.
 * See table below for the number of foot elements required for the PCB length

 Dimensions:

 Ordering Notes:
 * Supply 1pc each
 * Minimum components for one support: 2 end covers, extruded base (cut to size), DIN-Rail foot element plus 4 assembly screws
 * Extruded Base Section - xxx = Your PCB length less 4mm (we will supply the base extrusion pre-cut to this dimension)
    e.g. 200mm PCB = base extrusion cut to 196mm - order Part # CIME/E/BE196
    Please note minimum length for extruded base section 100mm
 * Foot Element - suitable for EN 50 022 (TS 35)/ ...035 (TS 32)/ ...045 (TS 15) rails.
 * See table below for the number of foot elements required for the PCB length

 Assembly Dimensions:

 Component Dimensions:

 Component Clearance:
 Each end cover has a 30 mm x 1.25 mm deep support on its inside wall and there is a 1 mm lip top and
 bottom on all elements. Solder side structures (cropped pins etc.) should be 3 mm clear of the top and
 bottom of the PCB to avoid the underside of the PCB slot

 Ordering Notes:
 Supply 1pc each
 Minimum components for one support: 2 end sections with/without foot.
 Combining these parts with intermediate base sections allows the nearest PCB length to be accomodated.

 The PCB widths are calculated by adding up the PCB L dimensions of the individual parts.
 * End section with foot - suitable for EN 50 022 (TS 35) rails.

 Dimensions:

 Component Clearance:
 Each base element has a 1.25 mm lip top and bottom. Solder side structures (cropped pins etc.)
 should be 4 mm clear of the top and bottom of the PCB to avoid the underside of the PCB slot

 Ordering Notes:
 Supply 1pc each
 Minimum components for one support: 2 end sections with/without foot.
 Combining these parts with intermediate base sections allows the nearest PCB length to be accomodated.

 The PCB widths are calculated by adding up the PCB L dimensions of the individual parts.
 * End cover with foot - suitable for EN 50 022 (TS 35) rails.
 * Intermediate part with foot - suitable for EN 50 022 (TS 35)/ ...035 (TS 32)/ ...045 (TS 15) rails.